AutoDoor Experts
Account
New Quote

Camden CM-3030 – Push/Pull Button, N/O, Maintained

$50.00

Push/Pull Button, N/O, Maintained

SKU: CM-3030
Category:
Brands:

Description

Series: CM-3000/3100 Series

Type: Illuminated Mushroom Pushbutton

Configuration: Single Gang Faceplate

Push/Pull Button, N/O, Maintained

Brand: Camden

Manufacturer Part Number: CM-3030

Source: Camden Controls product page

Reviews

There are no reviews yet.

Be the first to review “Camden CM-3030 – Push/Pull Button, N/O, Maintained”

Your email address will not be published. Required fields are marked *

Camden Door Controls CM-3000/3100 Series Exit Switches are heavy duty push-buttons designed for industrial and commercial applications where illumination is required. Buttons are 1 5/8" (40mm) in diameter, available in red or green, with a 1/4" thick brushed aluminum faceplate in 1 3/4" or 2 3/4" widths. The switches are UL/CSA approved, rated 10 amps @ 30V DC, for either momentary or maintained operation.

Product specifications
Low-voltage wiring Required
BasisStructured, independently qualified product connection evidence
PreparationThe supplied evidence gives product dimensions and says the switch can be surface, flush or mullion mounted. It does not give a mounting box depth, cutout size or prepared-surface requirement for CM-3030. The installation manual was not supplied.
ElectricalCM-3030 uses a N/O SPST contact block with maintained push/pull action. For a selected direct 12/24 VDC control circuit, connect the two-conductor switching loop to common and normally open. The LED supply is separate: connect two supply conductors at X1/X2 directly for 12 VDC; for 24 VDC put the supplied resistor in series with either X1 or X2. These interface counts do not state how many cable jackets/runs to pull. Field wire type and gauge are not specified by this manual; factory lead sizes are not field cable requirements.
Preparation requiredYes
Electrical wiring requiredYes
Conditional connectionsSeparate LED low-voltage supply at X1/X2: cable runs quantity unspecified; 2 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating Field wire type, conductor size, shielding and physical run quantity are not specified by this manufacturer manual. Select for the actual low-voltage system and site.; endpoints External selected12/24VDC supply to LED terminals X1 and X2; when Installation configuration is Selected direct12VDC supply:connect X1/X2 directly. Selected24VDC supply:insert the supplied resistor in series with either X1 or X2. This is the external LED supply pair, separate from the switch loop; physical cable runs are unknown.; N/O SPST low-voltage controlled contact circuit: cable runs quantity unspecified; 2 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating Field wire type, conductor size, shielding and physical run quantity are not specified by this manufacturer manual. Select for the actual low-voltage system and site.; endpoints CM-3030 N/O SPST contact block to Selected external12/24VDC controlled circuit; when Installation configuration is Selected12/24VDC control circuit with maintained push/pull operation. Use common and normally open as the two external points of this selected direct switching loop. Factory tails, unused terminals and LED supply are excluded from this interface count. Physical cable runs remain unknown.

Official manufacturer documents

Related products