Description
Variant record created for schedule matching; price inherited from product #1233 pending owner confirmation.
LCN 9563 Operator
$450.00
Variant record created for schedule matching; price inherited from product #1233 pending owner confirmation.
Additional information
| handing | LH, Non-handed, RH |
|---|---|
| finish | 628, 710, 711 |
| voltage | 115V, 230V |
| arm | LNGTLS2, LONG2, REG/STD, REG2, STDTRACKARM2, TLS/STD, TLS2 |
| Low-voltage wiring | Connection count needs review |
|---|---|
| Preparation | Check the approved opening drawings and header clearances. Prepare header wire-access holes for the selected surface installation using template 740070. For mounting onto a 2-inch frame, consult the manufacturer to determine whether a mounting plate is required. |
| Electrical | For the documented 120 VAC configuration, provide a dedicated single-phase 60 Hz supply fused at 15 A at the side jamb, with approximately 12 inches of wire available to connect the operator. The manufacturer specifies a 3-wire supply and recommends UL-approved flexible conduit. The legacy model reference also lists an optional 240 V configuration; these 120 V instructions do not establish its wiring requirements. Accessory activation, safety and locking connections depend on the selected devices. |
| Preparation required | Yes |
| Electrical wiring required | Yes |
| Conditional connections | 120 VAC field power supply at side jamb to operator: cable runs quantity unspecified; 3 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating unspecified; endpoints Dedicated mains circuit at side jamb to Operator AC supply connection and header earth; when Installation configuration is IF the legacy operator is configured for the 120 VAC supply covered by manual 740132. Three field supply conductors per connection; this is not a total cable-run count. Optional 240 V configurations and accessory circuits are not established by this count.; Selected activation, safety and locking accessory circuits: cable runs quantity unspecified; conductor count unspecified; wire type not documented; size unspecified; shielding unspecified; rating unspecified; endpoints Senior Swing control box to Selected activation, safety or locking device; when Installation configuration is Optional accessory selected: IF an activation, safety or locking accessory is selected, follow its own instructions. Conductor counts and cable-run quantities remain unknown here.; 120 V AC supply to the operator (power only, separate from control wiring): cable runs quantity unspecified; conductor count unspecified; wire type not documented; size unspecified; shielding unspecified; rating unspecified; endpoints 120 V dedicated branch circuit at side jamb to operator in header; when Installation configuration is Senior Swing surface and concealed installations per the generic instructions (applicability to 9563 inferred from the Senior Swing family only). The 3-wire supply (line, neutral, ground per instruction text) is fed through conduit into the header, with at least 12 inches of wire left in the header for final hookup. 115 V is the 9563 default voltage and 240 V is an option; the instructions cover the 120 V case only. Cable run count and conductor gauge are not documented. The page 5 figure 2-3 shows conduit and wire entering the jamb and header, but the number of cable runs is not determinable. |
Related products
-
2810IQ Series
$350.00 -
2850IQ Series
$450.00 -
2860IQ Series
$450.00 -
4630 Series
$350.00 -
4640 Series
$350.00
Reviews
There are no reviews yet.