AutoDoor Experts

Camden CM-4000/50N – N/O switch block and contact for CM-3000-8000

$50.00

N/O switch block and contact for CM-3000-8000

SKU: CM-4000/50N

Category: Actuators

Brands: Camden

Description
Reviews (0)

Description

Series: Parts for Push Buttons

Configuration: Contact Blocks/Switches

N/O switch block and contact for CM-3000-8000

Brand: Camden

Manufacturer Part Number: CM-4000/50N

Source: Camden Controls product page

Reviews

There are no reviews yet.

Be the first to review “Camden CM-4000/50N – N/O switch block and contact for CM-3000-8000”

Product specifications
Low-voltage wiring	Required
Basis	Structured, independently qualified product connection evidence
Preparation	For installation in a compatible CM-4000 host, confirm the required contact arrangement and rear clearance before attaching or stacking the contact block. Insert circuit wiring into the top and bottom block terminals and tighten their screw terminals. Follow the actual numbered terminals and verify operation; mushroom-button colour does not identify NO versus NC contact function.
Electrical	The exact part is N/O switch block and contact for CM-3000-8000. In the documented CM-4000 host, each individual SPST contact circuit has two screw terminals. A direct low-voltage controller circuit uses two external conductors per selected NO or NC contact. The host manual gives6A at30VDC as a contact rating, not a supply requirement. Momentary or maintained operation depends on the installed actuator. Determine actual contact arrangement, field cable type, gauge, shielding, routes and physical run quantities from the installation design; independent contact circuits do not establish one cable jacket.
Electrical wiring required	Yes
Conditional connections	CM-4000/50N NO contact to external controller: cable runs quantity unspecified; 2 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating Field cable type, gauge, shielding and physical run quantity remain installation decisions.; endpoints Selected external low-voltage control circuit to Individual NO contact block terminal pair; when Installation configuration is When fitted in a compatible documented CM-4000 host with this individual SPST contact directly wired to a low-voltage controller. Counts apply per selected contact, not aggregate field cable runs.