AutoDoor Experts
Account
New Quote
camden cm 6050 – red,push to lock, key to release n/o & n/c, maintained

Camden CM-6050 – RED,PUSH TO LOCK, KEY TO RELEASE N/O & N/C, MAINTAINED

$75.00

RED,PUSH TO LOCK, KEY TO RELEASE N/O & N/C, MAINTAINED

SKU: CM-6050
Category: ,
Brands:

Description

Series: CM-6000 Series

Type: Locking Push Buttons

Configuration: Single Gang Faceplate

RED,PUSH TO LOCK, KEY TO RELEASE N/O & N/C, MAINTAINED

Brand: Camden

Manufacturer Part Number: CM-6050

Source: Camden Controls product page

Reviews

There are no reviews yet.

Be the first to review “Camden CM-6050 – RED,PUSH TO LOCK, KEY TO RELEASE N/O & N/C, MAINTAINED”

Your email address will not be published. Required fields are marked *

Camden Door Controls CM-6000 Series Locking Push Switches are heavy-duty push buttons for lock-out or emergency shut-down applications; once pushed, the red 2 3/8" button latches and cannot be reset unless a key is inserted and turned in the center locking cylinder. The UL/CSA approved switches are rated 6 amps @ 30V DC and supplied with a 1/4" thick brushed aluminum faceplate.

Product specifications
Voltage 12/24 VDC
Contact rating 6A @ 30 VDC
Temperature range -13°F to 158°F (-25°C to 75°C)
Switch type Maintained
Material 1/4" thick brushed aluminum
Dimensions 4 1/2'' H x 2 3/4'' W x 1 1/2'' D (114mm x 70mm x 38mm)
Low-voltage wiring Required
BasisStructured, independently qualified product connection evidence
PreparationProvide the single-gang mounting arrangement for this model and allow clearance behind its faceplate for the contact assembly and wiring. Secure the faceplate with its supplied mounting hardware. Insert wiring into the top and bottom contact-block terminals and tighten the screw terminals. Follow the numbered terminals and verify the installed contact blocks before commissioning; do not identify contact operation from the mushroom button color.
ElectricalFor a selected low-voltage controlled circuit, this maintained, push to lock and key to release model provides normally open and normally closed contact operation. Each used SPST contact connects through two external circuit conductors. Select the NO contact, NC contact, or both functions to match the controlled equipment; keep their terminal assignments distinct. Follow the numbered contact-block terminals. The wiring chart and supplied-spade-lead table use different color descriptions, so verify the actual block and lead set. Factory spade leads do not establish field cable-run count. Physical cable-run quantity, field cable type, gauge and shielding require the connected-device instructions and site routing. Contact-load ratings describe the switched circuit, not a separate switch power-supply requirement.
Preparation requiredYes
Electrical wiring requiredYes
Conditional connectionsSelected normally open switch-contact circuit: cable runs quantity unspecified; 2 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating Field cable type, gauge, shielding and physical run quantity unspecified; select for controlled device and site.; endpoints Selected low-voltage controlled equipment to CM-6050 normally open contact terminals; when Installation configuration is Standard CM-6050; use this normally open contact for the selected controlled function. Two conductors serve this contact; factory spade leads and physical cable-run quantity are separate.; Selected normally closed switch-contact circuit: cable runs quantity unspecified; 2 conductor(s); wire type not documented; size unspecified; shielding unspecified; rating Field cable type, gauge, shielding and physical run quantity unspecified; select for controlled device and site.; endpoints Selected low-voltage controlled equipment to CM-6050 normally closed contact terminals; when Installation configuration is Standard CM-6050; use this normally closed contact for the selected controlled function. Two conductors serve this contact; factory spade leads and physical cable-run quantity are separate.

Official manufacturer documents

Related products