36\” x 6\” Column™ aluminum side load push plate switch, anodized clear finish with built-in Kinetic no-battery wireless transmitter, receiver required
Series: CM-74/75 & CM-84/85 Series
Type: Column™ Push Plate Switches
Configuration: 6" Wide
36" x 6" Column™ aluminum side load push plate switch, anodized clear finish with built-in Kinetic no-battery wireless transmitter, receiver required
Brand: Camden
Manufacturer Part Number: CM-8536K
Source: Camden Controls product page
| graphic | /1 no graphic, /2 wheelchair, /20 wheelchair+foot icon, /2AL wheelchair+arrow left, /2AR wheelchair+arrow right, /3 push to open, /4 wheelchair+push to open, /40 wheelchair+push to open, /4AL wheelchair+push to open, /4AR wheelchair+push to open, /80 lock (red)+foot icon, /8B lock+push to lock, /8C lock symbol, /A2 active wheelchair, /A20 active wheelchair+foot i, /A4 active wheelchair+push t, /A40 active wheelchair+push t |
|---|
Camden's CM-74 and CM-75 Series top-activation Column push plate switches are surface mounted and designed for installations with no obstruction above the unit, offering a discreet appearance. The CM-84 and CM-85 Series side-activation Column switches are two-piece units with a surface-mounted back box, designed for use when an overhead obstruction prevents a top-activation model, when mounting on a narrow curtain wall, or when the unit must pass through a glass panel.
| Contact rating standard models | 15 A @ 30VDC |
|---|---|
| Contact rating vr models | 1 A @ 30VDC |
| Voltage vr models | 12 to 24 VDC +/- 10% |
| Contact type standard | momentary contact switch, single pole double throw, Form C |
| Contact type vr | common/normally open/normally closed |
| Depth (CM-84/85) | 2-1/4" (32mm) |
| Width (CM-74) | 4-1/2" |
| Width (CM-75) | 6" |
| Width (CM-84) | 4-1/2" |
| Width (CM-85) | 6" |
| Low-voltage wiring | Not required |
| Preparation | The CM-85 side load series is documented as 2-1/4" (32mm) deep, surface mount with an integral back box. The mounting surface must accommodate this depth. The CM-75SB surface box documents are for the CM-7536 top load column switch and do not apply to the CM-8536K. |
| Electrical | The CM-8536K has a built-in Kinetic no-battery wireless transmitter, and the manufacturer page says a receiver is required. The supplied evidence documents no wired power or control connection for the base transmitter. The receiver's wiring is separate and is not documented in the supplied evidence. |
| Preparation required | Yes |
| Electrical wiring required | No |
Reviews
There are no reviews yet.