Aluminum Column(tm) Push Plate Switch
Series: Kinetic by Camden™
Type: 900Mhz. No-Battery Wireless Door Control System
Configuration: CM-75 Series Column(tm) Switches
Aluminum Column(tm) Push Plate Switch
Brand: Camden
Manufacturer Part Number: CM-7536K
Source: Camden Controls product page
| graphic | /1 no graphic, /2 wheelchair, /20 wheelchair+foot icon, /2AL wheelchair+arrow left, /2AR wheelchair+arrow right, /3 push to open, /4 wheelchair+push to open, /40 wheelchair+push to open, /4AL wheelchair+push to open, /4AR wheelchair+push to open, /80 lock (red)+foot icon, /8B lock+push to lock, /8C lock symbol, /A2 active wheelchair, /A20 active wheelchair+foot i, /A4 active wheelchair+push t, /A40 active wheelchair+push t |
|---|
Kinetic by Camden is a 900 MHz no-battery wireless door control system that uses the energy generated by pressing the switch to power the wireless transmitter, eliminating batteries and their disposal. It pairs battery-less push plate switches with the compact CM-RX-90 wireless receiver (field-selectable momentary, delayed, or latching relay operation) and is compatible with all brands of automatic door operators for indoor or outdoor use.
| Frequency | 900 MHz Fixed Frequency |
|---|---|
| Range open air | Up to 300 ft |
| Range in operator header | Up to 70 ft |
| Temperature | -40°F to 185°F (-40°C to 85°C) switch; Alkaline receiver battery 32°F to 122°F (0°C to 50°C), Lithium -40°F to 122°F (-40°C to 50°C) |
| Input voltage | 12/24V, AC/DC (CM-RX-90 receiver) |
| Output | CM-RX-90: (1) SPDT relay, 3 modes |
| Current draw | CM-RX-90: 23mA – 43mA |
| Time delay | CM-RX-90: 1-30 seconds |
| Dimensions | CM-RX-90 receiver: 3-1/2"H x 1-1/2"W x 13/16"D (89mm x 38mm x 21mm) |
| Low-voltage wiring | Not required |
| Preparation | For the CM-7536K top-load Kinetic column, allow clearance above the installed unit to remove the actuation bar. Level the base and mark and drill the four mounting locations; use the manufacturer anchors and supplied fasteners suitable for the mounting surface. Prepare two separate wall recesses behind the Kinetic switches, each 1-1/8 inch wide x 1-7/8 inch high x 1-3/4 inch deep, with their centres 20-1/2 inches apart as shown in the mounting drawing. These recesses are mounting preparation, not wiring runs. Reassemble and test free movement, and pair both the top and bottom Kinetic transmitters with the compatible receiver. |
| Electrical | The exact CM-7536K push plate includes a no-battery Kinetic transmitter powered by operating the switch. No external power or field wiring is required for this standalone switch: zero cable runs; wire type is not applicable. Its separately installed receiver requires its own power and control wiring. |
| Preparation required | Yes |
| Electrical wiring required | No |
Reviews
There are no reviews yet.